We have a 3/8" port, 24 volt 2 speed boost pump for sale. I also have a 1/2" port, 12 volt 2 speed pump, if anyone is interested. Brad Simmons Airframes Inc. ...
Brad, How much do you want for the 24V pump. My kit was produced as a 12v airplane and I am switching to 24V.. If the pump is new, I am interested. Thanks, ...
Hi Dave, It belongs to a customer. He will want about 80% of new for it. I'm not sure what they are selling for now, to be honest. I do want to point out it...
I'm just starting with wiring and can use some advice on connectors. What kind of connectors did you use for the wires from the wings? Did you use a single...
Pete, One very important point in putting in the connector between the rudder and the Vert stab is that you need to make it accessible with the rudder in...
Pete, I'll put in a vote for the Deutsch (sp?)connectors that Lancair sells. We use them on lots of severe-duty applications in heavy trucks. They are very...
Yep - I vote for eliminating all the wires in the rudder as well. I have too little use for the rudder trim - and I think a little spring could do the job much...
Pete, I think it's a good idea leave the wires long coming out of the wings and the rudder so the connectors are far away from potential moisture. My rudder ...
Pete I attached a Wire run list spread sheet. It is very helpful to make one of these before you start wiring. It simplifies the wiring process. We make these...
Pete, You might want to look at the Weatherpack series. They are primarily used on autos and trailers. A great choice for fuel injection engines. They can be...
It's too quiet, so time for some humor. Way off topic but too hard to resist, probably not too many qualified applicants. I found the job for you!!!! DC-3...
Sam - We used Dynamat Xtreme and it made a big difference to me in noise reduction and the same for heat transfer from the engine thru the firewall. It is a...
Sam - From the looks of the stuff we installed, there is very little evidence that it will pop off at altitude. What kind were you looking at? Dynamat does...
Guys, I am having problems with my 430 WAAS upgrade. Since the upgrade, when I transmit with my King KX-125 radio, it causes the Garmin to loose satellite...
Wasn't finished with the post and hit send too soon. Most likely the problem is that you need a notch filter, but there could be other issues. The coax...
Joe, On my WAAS upgrade I had a similar problem with frequent loss of signal from every satellite - all the bars would drop together until the screen was...
Guys, I forgot to mention, the notch filter was the first thing I tried. My thinking was that the the dummy load device attached to the back of the offending...
Joe, The problem isn't your antenna most likely, but if you put the dummy load in place of the antenna, then yes the problem could still be in the transmission...
... Thanks for the suggestions. I've tried most of them, but perhaps my ground plane on the GPS antenna is not big enough. It is only slightly larger than the...
Joe, Sounds like the problem is spurious emissions coming directly from the radio. You might try wrapping it with aluminum foil poking a few small holes for...
Joe, I've following your discussion and agree with Ron that the problem is most likely spurious radiation out of the KX-125 getting into the GPS. Whether it's...
After reading Pauls post it dawned on me that I've seen this problem a couple of times before in certified airplanes after a 430W upgrade. I was thinking that...
For Mike Salzman--- How hard is it to move the manual over ride on your valve from Camping World? I hadn't tried mine until yesterday and as soon as I hit the...
