I am aware of one instance of fuel leaks developing with auto fuel by a gentleman in Tucson (I can't remember his name) because the alcohol added to the fuel...
I just got my new, fancy air induction system from Lancair. If anybody's interested, I can send a couple photos. I'm working with Lancair to get some photos...
Guys, I have attached a photo of the retainer clips I recieved from Lancair. Scott in the shop sent them to me, free of charge. I also found another photo of...
I'm starting to think about the "little" things. My kit only came with wing tie downs. Are you guys installing another tie down in the tail? Mike Easley ...
I'm getting close to making decisions on: Remote Oil Filter Air Oil Separator Engine Heater Any comments would be appreciated. Mike Easley Colorado Springs...
Mike, In answer to all your questions, I powder coated all of my torque and push-pull tubes. Yes, you need three tie downs. I got three in my kit, maybe you...
Does anyone have advice on installing the TruTrak roll servo? I've got two problems using the instructions supplied with the servo: 1) The 0.55" bushing used...
Mike: My kit came with a tie down for the rear also. I believe the instructions for the fuslage showed where and how to install the rear tie down. Eugene Long ...
Mike: I have an Aero Composite prop and they sent drawing for the spinner blade cutouts for clearance as the blades rotate for the constant speed prop. You ...
Joe, Cut the bushing until you have clearance from the support. I floxed in (4) studs (available from AS). I had to reroute my fuel lines to clear. TruTrak...
Joe, Here's what I found when I mounted my servo. The bushing worked out fine, except I had to grind a notch in the bulkhead so I could get the longer bolt ...
Mike I am interested. Thanks Ron Raby ... From: mikeeasley@... To: Lancair_ES@yahoogroups.com Sent: Saturday, August 02, 2003 9:04 AM Subject: [Lancair_ES]...
Joe I did it just like mike. I had to shorten the roll servo rod by a few inches. Luckily I had access to a lathe to shorten that rod. Ron Raby ... From:...
Remote Oil Filter - I'm going to hold off on the remote oil filter until it proves necessary. When I first mounted my IO550N and saw the filter was "upside...
Ron, I won't have my induction installed for a few weeks. Lancair is going to send me some new photos of the installation once Tim gets back from OSH. I can ...
Regarding the Walker Air-Oil Separator - you can check out the info at: http://www.airwolf.com/Products-WalkerAIRSEPS.htm One thing to consider is mentioned in...
I ordered the control cable kit from Lancair and it included a bracket 655-01 for the mixture cable. This bracket was too short and didn't mount securely. The...
Mike: Hi: Just joined this club. Met you at Sun& Fun this year. Could you send me some of the photos of the air induction system? As you know I am installing...
I'm in the process of hanging my engine and tried to simplify my life by ordering ALL the optional kits from Lancair - specifically the: baffling kit, hose...
Ed, Welcome! I'll take some photos today. I won't have it installed for a while, but I'll take more photos after it's in place. Mike Easley Colorado Springs...
Greg, I THOUGHT the same thing, buy all the kits and get EVERYTHING you need. I went back and forth with Lancair on where each hose goes. Just yesterday, ...
Greg, Mike Thanks for the research. I have run into the exact same problems. Most of them I have resolved. Still need to do the drains and cables. This job...
I haven't done the tach sensor yet. My engine came as a factory rebuilt engine - and included a 3 wire plug which Scott says can be used for the Tach. It...
