... That one sure brought a smile to my face :-) Personally I trust a Sony just about as far as I can throw it... At least we agree on the bottom line ;-) Take...
Hi, I try to figure out the exact battery - balancer connector connection of a Flightpower EVO20 4900mAh 6S1P Here are the pictures of the batt. And plug ...
Yeeeeeeeeeeees, Thank you so much! 2 days of searching, and finally measuring. This confirms my findings. ManuLRK ... From: lrk-torquemax@yahoogroups.com ...
Hi Ron, I remember an old article in LRK where you can switch between D ad Y and also run the windings of each phase in parallell or series. Do you have this...
Hi All, A few years ago someone posted a link to a youtube (probably) video of some indoor aerobatics, one man flew his plane for about 3 minutes to some very...
Hi Ron, I have noticed your name in many threads on LRK motors. I have just started a dedicated Internet group to develop a dedicated e-bike propulsion unit...
(@John, new members without posts are under moderation, that's why you did not see your messages. I 'rejected' your other two similar messages. From now on,...
... http://video.google.com/videoplay?docid=-5308904878478774147 John has a good memory. There have been thousands of indoor videos posted in the last few...
Goedendag ;) A www.neumotors.com outrunner, Steve has finally seen the light ;-) <http://www.rcgroups.com/forums/showthread.php?t=949864> Vriendelijke groeten...
Goedendag ;) Batterie, fils, aimant, video: http://www.supermagnete.de/fre/project86?switch_lang=1 Vriendelijke groeten ;-) Ron van Sommeren chez Nijmegem,...
http://www.hb.quik.com/~norm/motor/motorspinani.gif ... From: Ron van Sommeren <ronvans@...> Subject: [lrk] veryveryvery (very?) simple motor design To:...
Could this be done? I only need about 2000+ rpm, but a bit torque. Currently the motor is delta wound, but can anyone give me hints on how to go on conveting...
Hello, Rewinding a motor, I searched the message archieve and found this : Are these sayings correct? ManuLRK For a motor still to wind: 1) Wind 1 tooth with...
Hi, I did check the "drill method" Kv=rpm/Vac/1.41/0.95 formule on existing motors. This formula gets REALLY close to the manufactures mentioned Kv!!! An...
Goedendag ;-) More methods for determining Kv: http://www.bavaria-direct.co.za/ -> motor building info -> How to determine the Kv of a motor Or fill in the...
I am new to this and understand brushless dc motors are basically 3 phase motors, thus the 3 wires. I bought some 80mm dc brushless cooling fans for a project....
